![]() |
| Timo installing some new network equipment. (Photo: D. McKay-Bukowski) |
Showing posts with label network. Show all posts
Showing posts with label network. Show all posts
Thursday, 6 February 2014
New networking at KAIRA
We've just upgraded the internal network at KAIRA. This should improve the reliability and give us more remote control to individually power-cycle pieces of equipment. It also improves the internal LAN performance. All the changes have been made within the RF-container.
Wednesday, 18 December 2013
Repatching the RF-container data network
Recently, we discovered a bit of a problem with the recording of high-speed radar data at KAIRA. We have had some problems with the recording of UDP packets via our local
data computer kaira01. As part of the testing for the installation of the
new QNAP data recorders, we were also testing the UDP packet reception on
not just the QNAP box, but also one of the other KAIRA acquisition
machines, kaira03. As this work was being done in the RF-container, we
were physically in the container and running the software from there.
During this time, we noticed that simultaneous dropped packets on all four lanes would occur at precisely the moment that the air-conditioning cuts in. Suspecting possible power spikes somehow getting into the network we traced the cables. These turned out to be quite long (two were 7.5 m and the other two were 10 m) and surplus length was coiled in the sub-floor space under the racks close to some of the power distribution cables.
We therefore suspect that some packet loss might have been caused by spikes induced into these cables corresponding to power fluctuations. At the time we were checking this, we also noticed that the cables used were CAT-5, which are only rated to 100 Mbit/s.
We have now replaced all four cables with 3-m CAT-6 cables (rated to 1 Gbit/s). These cables route directly through the signal cable guides on the back of the racks and do not go anywhere near the sub-floor space.
We now see a noticeable improvement in packet reliability, although we still see the occasional lost packet.
During this time, we noticed that simultaneous dropped packets on all four lanes would occur at precisely the moment that the air-conditioning cuts in. Suspecting possible power spikes somehow getting into the network we traced the cables. These turned out to be quite long (two were 7.5 m and the other two were 10 m) and surplus length was coiled in the sub-floor space under the racks close to some of the power distribution cables.
We therefore suspect that some packet loss might have been caused by spikes induced into these cables corresponding to power fluctuations. At the time we were checking this, we also noticed that the cables used were CAT-5, which are only rated to 100 Mbit/s.
We have now replaced all four cables with 3-m CAT-6 cables (rated to 1 Gbit/s). These cables route directly through the signal cable guides on the back of the racks and do not go anywhere near the sub-floor space.
![]() |
| Re-patching work in the RF-container (Photo: D. McKay-Bukowski) |
We now see a noticeable improvement in packet reliability, although we still see the occasional lost packet.
Saturday, 21 July 2012
Setting up the networks
In parallel to the work on the tiles, it is also necessary to set up the computing and networks. This was done by Klaas Stuurwold from ASTRON. Klaas spent the entire time working in this spot behind the equipment racks. Here's a photograph of him in action.
Now, where have we seen this before, Klaas? Or does every LOFAR station come with a "Klaas Module" installed at the back of the RF-container? :-)
Now, where have we seen this before, Klaas? Or does every LOFAR station come with a "Klaas Module" installed at the back of the RF-container? :-)
Subscribe to:
Posts (Atom)


